澳洲10注册

MicroTek™ One Coat Micro Topping is a thin concrete overlay mix that can be applied on floors and walls. Available in a white or gray mix, our thin overlay can be colored with any of our 30 standard overlay colors.

DATA SHEET DOWNLOADS

澳洲10一码两期计划


Thin Concrete Overlay Micro Topping for Floors and Walls

Thin Concrete Overlay Micro Topping for Floors and Walls


SureCrete's Micro Topping is a single component thin concrete overlay that is a self-bonding cement based, for interior concrete surfaces. Micro-Topping was designed to yield an exceptionally smooth tight-troweled finish that can provide a new “blank canvas” for decorative concrete floors. It may also be placed vertically on interior walls, creating the look of Venetian plaster. The application can be accomplished by trowel or “magic trowel.” Micro Topping thin concrete overlay is prepared with gray cement or white cement that may accept Color Packs.

When restoring an old concrete surface, or even possibly some freshly poured ones, inevitably there is some discoloration and cracks or maybe even significant patching that has to be done. These blemishes on your concrete slab can easily show through any decorative stains or sealers applied to your finished surface. With Micro Topping thin concrete overlay, your newly created "blank canvas" can alleviate these issues, giving you a nice clean surface to begin creating your new custom floor designs. While it may take a professionally trained hand too tightly trowel a flat surface using Micro Topping, many of the designs you can create using this product can be achieved by even the new Do it yourself (DIY) homeowner.


澳洲10历史记录

  • Custom Floor Tile Patterns
  • "Slop-Trowel" Unique Floor Finish
  • Faux Slate Tile
  • Faux "Marbled" Floor Designs
  • Faux Venetian Plaster Wall Coating
  • Commercial Floor Coatings
  • Thin Concrete Resurface Repairing
  • Solid Color Floors
  • Blank Canvas for Eco-Stain
  • Custom Themed Thin Overlay
  • Screened-In Patios
  • Kitchen & Living Area Floors
  • Concrete Resurfacing Polished Look

澳洲10现场开奖直播

We'll show you the best way to use Micro Topping:

  1. Any surface receiving a cementitious coating must be clean, cured, sound and profiled. See our Surface Preparation products for more information on accomplishing this
  2. Make sure that temperatures will remain between 50 and 90 degrees Fahrenheit and there will be no precipitation in the applied areas for a 48 hour period following application.
  3. Add 5 quarts water per 40 lb bag to 5 gal bucket and mix in any color desired for integral coloring of Micro Topping
  4. Slowly introduce Micro Topping while continuously mixing and mix for a minimum of 1 minute once all product has been emptied into a container. Scrape the sides of the bucket to make sure there are no "dry pockets" that didn't get mixed properly.
  5. Mist the surface of the concrete with water, and pour out a generous amount of Micro Topping thin concrete overlay.
  6. Tightly trowel or squeegee the product over your entire application area.
  7. If you need a second coat of Micro Topping thin concrete overlay, only wait until the surface is properly cured - between 2-6 hours. Then just apply the same as the first layer!
  8. Once the surface is dry to the touch, it can accept stains and secondary colorants at this point and is also ready to receive a sealer. Typical indoor applications would utilize a polyurethane or polyaspartic sealer from our DuraKote line of products.

澳洲10开奖结果网址

澳洲10龙虎开奖结果

Not necessarily. It depends on completely upon the design you're looking for and the substrate you’re working with.

澳洲10大小玩法

They’re fairly simple to create, just check out our Design Ideas or Videos section for a few pointers. If nothing else, feel free to attend one of our local training opportunities throughout the country.

澳洲10走势软件

While mixing in large batches can be done, it is important never to mix up more than can be applied within a 45-minute time frame.

澳洲10五码计划两期

Micro Topping is applied at such a thin rate that imperfections will likely show through in the first coat of the product, this would be a case where a second layer would probably be desired.

澳洲10数据

Coverage Approx 200-300 square foot (Varies based on substrate and application)
VOC Rating 0 g/L
Shelf Life 1 year in original unopened container
Mixing Ratio 5-6 quarts water per 40 lb bag
Base Color White or Gray
Density 126.1 lbs/cubic foot
Compressive Strength ASTM C-109: 4,278 PSI @ 28 days
Flexural Strength ASTM C-348: 995 PSI @ 28 days
Tensile Strength ASTM C-190: 440 PSI @ 28 days
Abrasion Resistance ASTM D-4060: 28
days %loss – 500 cycles – less than 0.50%
Mosaic Shear ANSI A 118.4: 280 PSI @ 28 days
MicroTopping – Thin Concrete Overlays Part Numbers MicroTek™ One Coat SKU’s and UPC’s

White Thin Concrete Overlay For Floors and Wals – Micro Topping 40lb Bag Mix SKU: 25103003 | UPC: 842467106563
Gray Thin Concrete Overlay For Floors and Wals – Micro Topping 40lb Bag Mix SKU: 25103002 | UPC: 842467106570

 

 

澳洲10开奖结走势图

Thin Concrete Overlay Micro Topping Smooth Tight Troweled MicroTek™ One Coat

Thin Concrete Overlay Micro Topping Smooth Tight Troweled MicroTek™ One Coat

澳洲10历史开奖号码

Color

White 40lb Bag Mix, Gray 40lb Bag Mix

澳洲10手机软件

There are no reviews yet.

Be the first to review “Thin Concrete Overlay Micro Topping Smooth Tight Troweled MicroTek™ One Coat”

Your email address will not be published.

澳洲10开奖历史记录

What ever you project project entails, Surecrete design products has virtually unlimited solid concrete stain colors available. Through our exclusive on-demand tinting system, Surecrete can provide just about any color you can imagine. All of our colors are made to be UV stable and are manufactured to withstand the harshest weather conditions including, heavy traffic, freeze-thaw conditions, and high heat climate areas.